« Transformers Castings
C-14 Muzzle Detail »

Sword Fitting Castings

SCA sword fittings, cast aluminum.

These are a spinoff project of the lost foam casting- sword hilts and pommels for the SCA. This batch of five will, hopefully, help raise a bit of money for a foam-cutting CNC setup.

This entry was posted on Tuesday, September 18th, 2007 at 11:25 am and is filed under SCA, metalcasting. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

One Response to “Sword Fitting Castings”

  1. william Says:
    September 7th, 2008 at 8:03 am

    hey, these are very nice, are you selling them? And if so, how much for a set, hilt and pommel?

Leave a Reply